Need help?Do you have a question about the NHR CAL Series and is the answer not in the manual?
General| AC Output Voltage | 0 to 300 V AC |
|---|---|
| Temperature Coefficient | ±0.01% of setting per °C |
| Input Range | 90V to 264V AC, 47Hz to 63Hz |
| Communication Interface | RS-232, USB |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 70 °C |
Critical safety precautions regarding live electrical circuits.
General description of the NHR CAL Series calibrator.
Explanation of communication protocols and methods used by the calibrator.
Definitions of key terms used in the manual.
Specifies the units used for various parameters.
Details on network configuration, IP addresses, and port usage.
Information on available software tools for calibration.
Guide to using the SCPI Test Panel utility.
Critical operational limits and warnings for the Cal300.
List of required software, hardware, and accessories for calibration.
Overview of calibration software and initial steps.
List of required software, hardware, and accessories for calibration.
Overview of calibration software and initial steps.
List of required software, hardware, and accessories for calibration.
Steps for SCPI-only calibration setup.
Selecting the specific module for calibration.
Configuring calibration equipment and parameters.
List of required software, hardware, and accessories for calibration.
Settings for defining calibration paths and results.
Procedure for measuring UUT voltage.
Procedure for measuring current using transducers.
Overview of standard SCPI commands.
Query list of maximum power for ESTAR resistors.
To Next Page