Nibe EME 20 - Advanced Connections and Settings (F-Series); Connecting Multiple Inverters (F-Series); Connecting the Energy Meter (F-Series); DIP Switch Configuration (F-Series)

F1345 without 2.0
AA3-X6
6 74 5
B
12V
A
1110982 3
4 5
6
71
21
AA3:X6
Inverter
AA23
EME 20
F1345 without2.0
Connecting multiple inverters to one EME 20
Twelve inverters of the same make can be connected
in parallel to one EME 20.
21 21
21
111098
EME 20
Inverter 1 Inverter 2 Inverter 3
Connecting the energy meter
To connect the energy meter (optional), see the Installer
Manual for the main product.
DIP SWITCH
The DIP switch (S2) on the communication board (AA23).
Default OFF.
ON
1
2
3 4
6
5
87
Program settings
Program setting for EME 20 can be performed via the
start guide or directly in the menu system in NIBE heat
pump/indoor module/control module.
TIP
Also, see the Installer Manual for the heat
pump/indoor module/control module.
START GUIDE
The start guide appears upon first start-up after installa-
tion of the heat pump/indoor module/control module,
but is also found in menu 5.7.
MENU SYSTEM
If you do not make all settings via the start guide or need
to change any of the settings, this can be done in the
menu system.
MENU 3.1 – SERVICE INFO
Displays information about available functions.
Select: Solar accessory
Explanation for control mode 1-4 when the sun symbol
is lit in heat pump/indoor module/control module.
This function has four different action modes, depending
on the power supplied by the solar panels.
The SUN symbol lights up in the display by indoor cli-
mate depending on control mode 1-4:
ExplanationMode
<250 W No symbol is lit. No action in heat
pump/indoor module/control module.
Mode 1
>250 W Symbol is lit. The values are
shown in service info No action in heat
pump/indoor module/control module.
Mode 2
>1 kW* Lit symbol. If there is no need ac-
cording to operating prioritisation, the AUX
output is closed if it is set to photovoltaic
control.
Mode 3
EME 20 F-series | GB38
F