Nibe SAM 42 - The Heating Installation - The Heart of the House

Removing the covers
FRONT COVER
1.
Remove the service cover by pulling it straight out.
L
EK
Mounting
INSTALLING ON BRACKETS
1.
Install SAM 42 on brackets (accessory BAU 40) as
illustrated below.
2.
Connect heating medium pipes and ventilation ducts.
LEK
3 - 5 mm
INSTALLING ON WATER HEATER
VPB 200
1.
Remove the service cover from VPB 200.
2.
Remove the top panel from VPB 200 (installed with
6 screws).
3.
Install DEW 40 according to the instructions in the
installation manual. The pipes in VPB 200 can be
adjusted/replaced in such a way that SAM 42 can
easily be installed above VPB 200.
4.
Install SAM 42 from the top and slide into position.
LEK
5.
Secure SAM 42 with the 2 screws supplied.
LE
K
6.
Connect heating medium and ventilation pipes.
7.
Reinstall the service cover on VPB 200.
SAM 42Chapter 2 | Delivery and handling8