Nibe SMO 20 - Start-Up and Inspection

Start-up and
inspection
START GUIDE
NOTE
There must be water in the climate system
before the switch is set to " ".
1.
Set switch (SF1) on SMO 20 to position "".
2.
Follow the instructions in the display's start guide.
If the start guide does not start when you start the
SMO 20, start it manually in menu 5.7.
TIP
See the section "Control – Introduction" for a
more detailed introduction to the installation’s
control system (operation, menus, etc.).
Commissioning
The first time the installation is started a start guide is
started. The start guide instructions state what needs
to carried out at the first start together with a run
through of the installation’s basic settings.
The start guide ensures that start-up is carried out cor-
rectly and cannot be bypassed. The start guide can be
started later in menu 5.7.
During the start-up guide, the reversing valves and the
shunt are run back and forth to help vent the heat pump.
Caution
As long as the start guide is active, no function
in SMO 20 will start automatically.
The start guide will appear at each restart of
SMO 20, until it is deselected on the last page.
Operation in the start guide
language4.6
If the start guide is left on this page it closes
automatically in
60 min
A. Page
C. Option / setting
B. Name and menu number
A. Page
Here you can see how far you have come in the start
guide.
Scroll between the pages of the start guide as follows:
1.
Turn the control knob until one of the arrows in the
top left corner (at the page number) has been
marked.
2.
Press the OK button to skip between the pages in
the start guide.
B. Name and menu number
Here, you can see which menu in the control system
this page of the start guide is based on. The digits in
brackets refer to the menu number in the control sys-
tem.
If you want to read more about affected menus either
consult the help menu or read the user manual.
C. Option / setting
Make settings for the system here.
D. Help menu
In many menus there is a symbol that indicates
that extra help is available.
To access the help text:
1.
Use the control knob to select the help symbol.
2.
Press the OK button.
The help text often consists of several windows that
you can scroll between using the control knob.
NIBE SMO 20Chapter 6 | Commissioning and adjusting30