Menu system
INDOOR CLIMATE
HOT WATER
INFO
HEAT PUMP
SERVICE
Indoor temperature -
(if room sensors are
installed)
Hot water temp.
Temporary lux (if
activated)
Outdoor
temperature
Estimated amount of
hot water
MENU 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See informa-
tion in the help menu or user manual.
MENU 2 - HOT WATER
Setting and scheduling hot water production. See inform-
ation in the help menu or user manual.
This menu only appears if a water heater is installed in
the system.
MENU 3 - INFO
Display of temperature and other operating information
and access to the alarm log. See information in the help
menu or user manual.
MENU 4 - MY SYSTEM
Setting time, date, language, display, operating mode
etc. See information in the help menu or user manual.
MENU 5 - SERVICE
Advanced settings. These settings are not available to
the end user. The menu is visible when the Back button
is pressed for 7 seconds, when you are in the start
menu. See page 38.
SYMBOLS IN THE DISPLAY
The following symbols can appear in the display during
operation.
DescriptionSymbol
This symbol appears by the information sign
if there is information in menu 3.1 that you
should note.
These two symbols indicate if the compressor
in the outdoor module or the additional heat
in the installation is blocked via SMO 20.
These can, for example, be blocked depend-
ing on which operating mode is selected in
menu 4.2, if blocking is scheduled in menu
4.9.5 or if an alarm has occurred that blocks
one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase or
lux mode for the hot water is activated.
This symbol indicates whether "holiday set-
ting" is active in 4.7.
This symbol indicates whether SMO 20 has
contact with NIBE Uplink.
This symbol is visible in installations with
active solar accessories.
This symbol indicates whether cooling is act-
ive.
Heat pump with cooling function required.
NIBE SMO 20Chapter 7 | Control - Introduction32
To Next Page
Loading...
