Nibe SMO 20 - Adjusting the Heat Pump; Internet Connectivity Setup

Additional heating only
If you are unsuccessful in rectifying the fault and are
unable to heat the house, you can, whilst waiting for
assistance, continue running the heat pump in ”add.
heat only”. This means that additional heating only is
used to heat the house.
SET THE INSTALLATION TO ADDITIONAL
HEAT MODE
1.
Go to menu 4.2 op. mode.
2.
Mark ”add. heat only” using the control knob and
then press the OK button.
3.
Return to the main menus by pressing the Back
button.
Caution
When commissioning without NIBE air/water
heat pump, the "communication error" alarm
may appear in the display.
The alarm is reset if the relevant air/water heat
pump is deactivated in menu 5.2.2 ("installed
heat pump").
NIBE SMO 20Chapter 10 | Disturbances in comfort48