Nibe SMO 20 - SMO 20 Benefits; User-Friendly Display

Wall installation
NOTE
For wall mounting, use screws suitable for the
surface.
110
410
360
110
10
310
215 70
35
Use all mounting points and install SMO 20 upright flat
against the wall without any part of the control module
protruding beyond the edge of the wall.
Leave at least 100 mm free space around the control
module to facilitate access and cable routing on installa-
tion and service.
Caution
Screws for removing the front cover are
reached from underneath.
Supplied components
Heating pipe pasteOutside sensor
LEK
Temperature sensorInsulation tape
LEK
Cable tiesAluminium tape
9Chapter 2 | Delivery and handlingNIBE SMO 20
2 Delivery and handling