Set the temperature (with room sensors installed and activated):
Setting range: 5 - 30 °C
Default value: 20
The value in the display appears as a temperature in °C if the heating system
is controlled by a room sensor.
To change the room temperature, use the control knob to set the desired
temperature in the display. Confirm the new setting by pressing the OK but-
ton. The new temperature is shown on the right-hand side of the symbol in
the display.
Setting the temperature (without room sensors activated):
Setting range: -10 to +10
Default value: 0
The display shows the set values for heating (curve offset). To increase or re-
duce the indoor temperature, increase or reduce the value on the display.
Use the control knob to set a new value. Confirm the new setting by pressing
the OK button.
The number of steps the value has to be changed to achieve a degree change
of the indoor temperature depends on the heating unit. One step for under
floor heating whilst radiators may require three.
Setting the desired value. The new value is shown on the right-hand side of
the symbol in the display.
Caution
An increase in the room temperature can be slowed by the thermostats for
the radiators or under floor heating. Therefore, open the thermostats fully,
except in those rooms where a cooler temperature is required, e.g. bedrooms.
25NIBE™ VVM 500Chapter 3 | VVM 500 – at your service
To Next Page
Loading...
