6 – ENGLISH
6
If the door to be automated is an overhead type, check whether distance E in “Figure 7” is observed, which refers to the minimum dis-
tance between the upper side of the guide and the maximum point reached by the upper edge of the door. If not, the gearmotor cannot
be installed.
E 65 ÷ 300 mm
C 3158 mm D 360 mm
A 40 ÷ 400 mm
B 0 ÷ 400 mm
7
3.6 INSTALLING THE GEARMOTOR
a
Incorrect installation may cause serious physical
injury to the person working on the system or to its
future users.
Before starting to assemble the automation, com-
plete the preliminary checks described in the “Pre-
installation checks” paragraph (page 4) and the “
Product usage limits” paragraph (page 4).
a
The automation must be installed EXCLUSIVELY
WITH THE DOOR CLOSED.
To install SPIDO:
1. assemble the guide by sliding the two ends (A) into the join-
ing element (B) until they touch (“Figure 8“)
A
B
A
8
To Next Page
Loading...
