17
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/O switch, the indicator will
light up. Then the kettle will start to boil the water, once the water is boiled, the On/O
switch will be o automatically. You can shut o the power by lifting On/O switch at any
moment during boiling water. If you want to boil water again, only press down the On/O
switch directly to restart the kettle.
NOTE: Ensure that the On/O switch is free of obstructions and the lid is rmly closed,
the kettle will not turn o if the switch is constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, please do not open the lid while the water is boiling, and position
the lid so that steam is directed away from the handle.
6. The kettle will not re-boil until the On/O switch is pressed down again. The kettle may be
stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
7. The heating element surface is subject to residual heat after use.
8. Insert the plug in 220-240V~ power source.
9. Choose function you need from below:
Function 1: Press “on/o” button, heating the water to 100 degree
Function 2: Press “on/o” button rstly, then press “+/-” button to select the temperature (40-55-70-
85°C) you need. Water can be heated to 100 degree rstly and kept at the temperature you chose.
Function 3: Press “+/-” button rstly to select temperature (40-55-70-85°C) you need, then press
“on/o” button. Water can be heated to and kept at the temperature (40-55-70-85°C) you selected.
To implement this function, please make sure using puried water.
Every function nished, there will be alerting sound.
If you need to stop the heating, please press the “on/o” button.
To Next Page
Loading...
