Nidec Answer Drives 1000 Series - Page 93

Summary
Preface P. 6
Chapter 2 P. 17
Technical data
Chapter 5 P. 76
Reception, storage
and installation
Chapter 4 P. 54
General information
Chapter 3 P. 47
Application notes
Chapter 6 P. 115
Options
Chapter 7 P. 129
Preventive maintenance
Chapter 1 P. 15
Overview
and installation diagram
Answer Drives 1000
93
5
JUMPER AND DIP-SWITCH
JUMPER AND DIP-SWITCH
P1
P2
P3
P4
P5
P6
P7
P8
P9
P29
P30
P33
P34
SW1
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
3 2 1
1-2
2-3
OFF
ON
ON
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
ON
OFF
OFF
1-2
2-3
1-2
2-3
Iu current from power board
Iu current recreated on the control board (only for drive <166)
Reserved (D.O.C. filtering)
P3=ON, P4=ON: connection of 220X termination resistor between TXRX+ and TXRX-
P3=OFF, P4=OFF: termination resistor between TXRX+ and TXRX-not connected
Analogue output in 0(4)-20mA current
Analogue output in ±10V (2mA) voltage (Default)
500X ballast resistor, analogue input 1, connected
500X ballast resistor, analogue input 1, not connected (Default)
500X ballast resistor, analogue input 2, connected
500X ballast resistor, analogue input 2, not connected (Default)
Analogue output in 0(4)-20mA current
Analogue output in ±10V voltage (Default)
P9=ON: The 24Vdc I / O power supply is available on terminals J12-30 and J12-31.
Do not connect any other external power supply.
P9 = OFF: it is necessary to connect to terminals J12-30 and J12-31 a 24Vdc external
power supply to power the I/O.
Not used
Not used
Pull-up excluded (Default)
Pull-up (2K2 ) on AI2 input (+) at +10V (for PTC)
Open (Reserved)
Open (Reserved to firmware installation)
Reset button
Modbus TXRX
Analogue output 2 AO 2
Analogue input 1 AI 1
Analogue input 2 AI 2
Analogue output 1 AO 1
Analogue input 2 AI 2