Nidec E300 Series - Page 203

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
Installation and System Design Guide 203
Issue Number: 1
Figure 8-4 Encoder Simulation
0
1
2
3
C31
Encoder Simulation
Mode
??.??
Any variable
parameter
??.??
C28
Encoder Simulation
Source
03.089
Encoder Simulation
Hardware Divider
C32
03.089
Encoder Simulation
Hardware
Marker Lock
C33
C30
Encoder Simulation
Sample Period
C34
Encoder Simulation
Incremental Mode
Select
C35
Encoder Simulation
Output Lines
Per Revolution
C36
C37
Encoder Simulation
Numerator
Encoder Simulation
Denominator
C38
Encoder Simulation
Output Roll-Over
Limit
C39
C40
Encoder Simulation
SSI Turns Bits
Encoder Simulation
SSI Comms Bits
C41
Encoder Simulation
Output Mode
Encoder simulation
output
C29
Encoder Simulation
Status
C01
Drive Encoder
Type
C29 None (0)= No simulated encoder outputs available
= Full simulated encoder outputs availableC29 Full (1)
including a marker output
= simulated encoder outputsC29 No Marker Pulse (2)
available with no marker output
Hardware
Lines Per Rev
Ratio
SSI
mm.ppp
mm.ppp
Key
Read-write (RW)
parameter
Read-only (RO)
parameter
Input
terminals
Output
terminals
X
X
X
X
The parameters are all shown in their default settings