Nidec E300 Series - Page 313

Installation and System Design Guide
313
N
NEMA rating ...........................................................51, 308, 309
Nominal elevator speed
........................................................173
Notes .........................................................................................9
O
Open loop mode ......................................................................18
Operating-mode selection
.....................................................145
Optimization ..........................................................................294
Option Module
.......................................................................239
Options
....................................................................................21
Output contactor ....................................................................106
Output frequency
...................................................................309
P
Parameter ranges .................................................................189
Parameter security
................................................................127
Parameter x.00 ......................................................................145
Planning the installation
..........................................................33
Power connections
..................................................................75
Power ratings ........................................................................108
Power terminals ......................................................................56
Precision reference Analog input 1
.........................................92
Product information .................................................................11
Programming error indications ..............................................252
R
Relay contacts .........................................................................94
Residual current device (RCD)
..............................................110
Resistances (minimum) .........................................................108
Resolution .............................................................................310
RFC-A mode
...........................................................................18
RFC-S mode ...........................................................................18
Routine maintenance ..............................................................66
S
Safe Torque Off .....................................................................122
Safe Torque Off/drive enable
..................................................94
Safety Information ......................................................9, 33, 308
Serial comms lead ...................................................................88
Serial communications look up table
.....................................293
Serial communications port isolation .......................................88
Shield, Ground connections ..................................................101
Source parameter
...................................................................89
Speed loop gains ..................................................................296
Speed range ..........................................................................309
Start up time
..........................................................................309
Starts per hour ......................................................................309
Status indications
..................................................................251
Status LED ............................................................................245
Storage ..................................................................................308
Supply types
............................................................................74
Surface mounting the drive .....................................................39
Surge immunity of control circuits - long cables and
connections outside a building
........................................121
Surge suppression for analog and bipolar inputs and
outputs ............................................................................122
Surge suppression for digital and unipolar inputs and
outputs
............................................................................121
T
Temperature ......................................................................... 308
Terminal block in the enclosure
............................................ 121
Terminal cover removal .......................................................... 34
Terminal sizes
........................................................................ 58
Thermal protection circuit for the braking resistor
................ 110
Through-panel mounting the drive .......................................... 44
Torque settings
....................................................................... 58
Trip codes ............................................................................. 265
Trip Indications
..................................................................... 252
Trip reset
.............................................................................. 248
U
User Menu A ......................................................................... 139
User Security ........................................................................ 127
V
Ventilation ............................................................................... 50
Vibration
............................................................................... 309
W
Warnings ..........................................................................9, 308
Weights
................................................................................. 311