F3: System Mode
42-02-2M01 A1 4-55
4
Motion 4000
F3: System Mode
System mode allows the user to change certain system-wide options that do not require the car
to be on Inspection. To enter System mode:
•Move the F3 switch to the up position (all others down).
• Press N to select the desired System Mode item.
• Building Security Menu (see page 4-55)
• Passcode Request Menu (see page 4-57)
• Load Weigher Thresholds (see page 4-58)
• Analog Load Weigher Learn Function (see page 4-58)
• Controller System Menu - real time speed and position indication (see page 4-51)
Building Security Menu
The Building Security described here is independent of Card Reader security. If one is used, the
other security method should be inactive. Building Security is used to limit access to specified
floors to passengers with a valid security code. The Security code for each floor is a sequence of
button presses on the car operating panel and may consist of from one to eight “characters”.
Any floor with a programmed security code is a secured floor when Security is ON. Security is
turned ON or OFF by the controller Building Security Input (BSI) in combination with the BSI
Security Key parameter in the Extra Features Menu (Program mode). There are three possible
settings for the Building Security Key: ACTIVATED, ENABLED, and DEACTIVATED:
• If set to ACTIVATED, Security is ON.
• If set to ENABLED, Security is ON when the BSI input is turned ON.
• If set to DEACTIVATED, Security is OFF regardless of the status of BSI.
To find the BSI input, refer to the job prints. When Security is ON, car calls are registered only if
the call is not to a secured floor or the call is to a secured floor and the security code is correctly
entered within 10 seconds.
Viewing The Building Security Menu
1. Place the F3 switch in the up position (all other switches
down). The following display appears:
2. Press the N push button. The following display appears:
Programming And Viewing The Security Codes
1. Press S to start changing or viewing Security codes.
If no code has been programmed, the computer displays
NO CODE PROGRAMMED for that particular floor.
Press S again to start programming the Security code.
If a code has already been programmed, the computer dis-
plays the security code with the floor number blinking.
2. Press + to increment or
– to decrement floor number.
To Next Page
Loading...
