NE200/300 Series Drive User Manual
214 Appendix B: Adapted Encoder Instruction
Appendix C: Adapted encoder instruction
Fig B-1
Fig B-1 is the wiring method of the collector of encoder. The encoder power
supply may be the 24V of drive while the encoder Vcc is 24V, may use the
5~24V power supply while using the external encoder.
Fig. B-2
Fig. B-2 is the encoder wiring method in Push-pull output or voltage
output modes. The encoder power supply Vcc is 24V and drive’s 24V is
recommended.
Note:
To Next Page
Loading...
