NE200/300 Series Drive User Manual
24 Chapter 2 Drive Installation
Fig.2-3 Removal of keypad Fig.2-4 Mounting of keypad
2.3.2 Removal and mounting of drive plastic enclosure
Removal of cover
Forcefully press the 2 snap joints on the left and right sides as shown
direction1 until the upper side of cover comes out. Lift the cover in direction
2, as in Fig. 2-5.
Mounting of cover
After the wiring of main circuit terminals and control circuit terminals,
insert the two snap hooks on the bottom part of the facial cover into the
groove of the drive body, as shown in direction 1 in Fig.2-6, and then press
the front cover in direction 2 as shown in Fig.2-6, until the “crack” sound is
heard.
Fig.2-5 Removal of cover Fig.2-6 Mounting of cover
To Next Page
Loading...
