NE200/300 Series Drive User Manual
218 Appendix B: Adapted Encoder Instruction
Fig. D-3 Drain connection wiring diagram
(Using internal +24V)
NPN common-emitter connection wiring
(Using internal +24V)
Note:
Short-connect PLC and +24V
Fig. D-4 NPN common-emitter connection wiring
(Using internal +24V)
CAN
non-standard protocol instruction
CAN ID1 transmitting and receiving data format is constant as Table D-1.
Adjust to decrease interval time, suggest within 1.5ms, of host transmitting, to
increase interval time of slaver device.
To Next Page
Loading...