15
English
Disposal method
①
Remove the broken stainless steel wire.
②
Secure the wire to point A.
③
Slightly bend the cutter in direction B and then
secure the wire to point C.
If the stainless steel wire is broken, replace it as follows:
• Purchase a commercially available stainless
steel wire (piano wire) Φ1.2mm.
Extruding slot
Cutter
Stainless steel wire
A
B
C
Replacing the stainless steel wire (to cut clay)
Note)
The packing (rubber ring) may degrade over time due to
continuous usage and/or various external conditions. Please
check regularly and replace accordingly to maintain optimum
performance.
• Contact your local government as the disposal method diers depending on local governments.
• Do not disassemble the NVS-07 when disposing of it.
Note)
The packing (rubber ring) may degrade over time due to continuous usage and/or various external conditions.
Please check regularly and replace accordingly to maintain optimum vacuum performance.
To Next Page
Loading...