Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
NV Media
Card
Onboard
PLC
Advanced
parameters
Diagnostics UL Listing
Unidrive M200 / M201 Control User Guide 97
Issue Number: 2
* If this parameter is read via serial communications, it will show pole pairs.
05.080 Low acoustic noise enable Off (0) or On (1) Off (0) RW Bit US
05.081
Change to maximum drive switching fre-
quency at low output current
Off (0) or On (1) Off (0) RW Bit US
05.083 Voltage Shelving Disable Off (0) or On (1)
Off (0) RW Bit US
05.084
Low Frequency Slip Boost 0.0 to 100.0 %
0.0 % RW Num US
Low Frequency Estimator Threshold
0.0 to 100.0 % 0.0 % RW Num US
05.088 Ur Mode Pre-Flux Delay 0.0 to 0.7 s
0.1 s RW Num US
RW Read / Write RO Read only Num Number parameter Bit Bit parameter Txt Text string Bin Binary parameter FI Filtered
ND No default value NC Not copied PT Protected parameter RA Rating dependent US User save PS Power-down save DE Destination
Parameter
Range () Default ()
Type
OL RFC-A OL RFC-A
To Next Page
Loading...
