Nidec Unidrive M700 - Menu 21 - EtherNet;IP In Mappings

SI-Ethernet User Guide 111
Issue: 3
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started
Parameters
Key features
and Protocols
PC Tools
Applications
Security Diagnostics
Glossary of
terms
Index
6.1.8 Menu 21 – EtherNet/IP In Mappings
This menu contains the parameters used to define the source parameters for data that will be
transmitted to the PLC.
S.21.001 Input mapping parameter 1
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
10040
(Display: 0.10.040)
Units None
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/IP
interface enable
Display Format Slot Menu Param Decimal Places 0
Coding RW, PT, BU
S.21.002 Input mapping parameter 2
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
2001
(Display: 0.02.001)
Units None
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/IP
interface enable
Display Format Slot Menu Param Decimal Places 0
Coding RW, PT, BU
S.21.003 Input mapping parameter 3
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
0
(Display: 0.00.000)
Units None
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/IP
interface enable
Display Format Slot Menu Param Decimal Places 0
Coding RW, PT, BU