Nidec Unidrive M700 - Menu 9 - Ethernet Resources

SI-Ethernet User Guide 49
Issue: 3
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started
Parameters
Key features
and Protocols
PC Tools
Applications
Security Diagnostics
Glossary of
terms
Index
The following table list the possible error codes:
S.MM.PPP + 6 : Parameter value ( MSW )
This parameter:
• Stores the most significant word of the value to be written to the destination parameter if the
command is Write (3) or
• Stores the most significant word of the value read from the destination parameter if the
command is Read (2) and the status is OK (3)
6.1.3 Menu 9 – Resources
The number of available transmit cyclic links.
Value Meaning Description
-1 Address Type The addressing type is not supported.
- 2 Timeout A timeout occurred trying to access the specified item.
-3 Access Denied The requesting device does not have sufficient access rights.
-4 Does not exist The specified item does not exist.
-5
Data Type The data could not be converted from the specified type.
-6 Failed Read The value could not be read, reason unknown.
-7 Failed Write The value could not be written, reason unknown.
-8 Not Readable The data could not be read as the source does not allow read access.
- 9 Not Writeable The data could not be written as the destination does not allow write access.
-10 Over Range The specified value is outside the suitable range for the item.
-11 Request
Invalid The request contained invalid information.
- 12 Response Too Big The response will not fit in the maximum response size.
-13 Decimal Place
The decimal place information is invalid (i.e. out of range of allowed values for
a write).
-14 Invalid Param Invalid parameter in the parameter channel.
-15 Invalid CMD Invalid command.
-16 Invalid
IP Invalid IP address.
-17 Unknown Error An unknown error happens.
-18
to
-128
Reserved Reserved for future use.
S.09.001 Cyclic Tx Links Free
Minimum 0 Maximum 255
Default None Units None
Type 8 Bit Volatile Update Rate Background write
Display Format None Decimal Places 0
Coding RO, ND, NC, PT, BU