Nidec Unidrive M700 - Page 81

SI-Ethernet User Guide 81
Issue: 3
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started
Parameters
Key features
and Protocols
PC Tools
Applications
Security Diagnostics
Glossary of
terms
Index
Defines the event to trigger in the given destination, as specified in Rx3 Timeout Event Destination
(S.10.067), if a cyclic data timeout occurs on the Rx3 link.
S.10.068 Rx3 Timeout Event Type
Minimum
0
(Display: No Event)
Maximum
4
(Display: Event3)
Default
0
(Display: No Event)
Units None
Type 8 Bit User save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, Txt, BU
Value Text Description
0 No Event No event
1 Event Trigger module event
2 Event 1 Trigger module event 1
3 Event 2 Trigger module event 2
4 Event 3 Trigger module event 3
This feature is not yet implemented.
S.10.069 Rx3 Link Status
Minimum
-31
(Display: Disabled)
Maximum
2
(Display: OK sync)
Default None Units None
Type 8 Bit Volatile Update Rate Write on reset
Display Format None Decimal Places 0
Coding RO, Txt, NC, ND, PT
Value Text Description
-31 Disabled Easy Mode protocol is disabled or link number set to 0
-30 VLAN disabled
VLAN is required in order to guarantee timing in
synchronous mode but it is disabled
-29 Reserved 29 Reserved for future use
-28 Reserved 28 Reserved for future use
-27 Reserved 27 Reserved for future use
-26 Reserved 26 Reserved for future use
-25 Reserved 25 Reserved for future use
-24 Reserved 24 Reserved for future use
-23 Reserved 23 Reserved for future use
-22 Invalid DST IP Destination IP address is invalid
NOTE