Thank you for purchasing the Kestrel 1000 Pocket Wind Meter. This
instrument will measure the following environmental conditions:
• wind speed
• maximum wind gust
• average wind speed
This instrument also features a data hold function and an automatic
power-down function. Every unit is fully tested at our factory for
measurement accuracy and waterproof integrity. The one-year war-
ranty can be extended to two years by simply filling out the attached
registration card.
OPOP
OPOP
OP
ERER
ERER
ER
AA
AA
A
TIONTION
TIONTION
TION
1) Slide off cover. 2) Turn on: Press the center
button (
) to turn on the unit.
3) Select operating mode. Press the right arrow ( ) to scroll through
the measurements listed below. Press the left arrow (
) to scroll
through the measurements in reverse order. The instantaneous
measurements will be displayed. (See Understanding the Measure-
ments section for more information.)
5) Hold mode. Press
while holding to hold the measured
value on the display. The word “HOLD” will blink to indicate the
Hold Mode. Press
while holding to exit the Hold Mode. This
mode can be useful for taking measurements when unable to
view the display, as within a duct. The Max and Avg Wind Speed
Modes will continue to work as usual.
6) Turn off. Hold for 2 seconds to manually turn off the unit.
The unit will automatically turn off if no buttons have been
pressed for 45 minutes.
UNDERSTANDING THE MEASUREMENTS
Wind Speed - average over the previous three seconds. The
measurement will be accurate for air flow through the front or rear
of the unit.
Maximum Wind Gust - maximum 3 - second wind speed since the
unit was turned on.
Average Wind Speed - average wind speed since the unit was turned
on.
MAINTENANCE & TROUBLESHOOTING
Storing Your Kestrel
Avoid storing your Kestrel where it will be exposed to temperatures
below -30°C [-22°F] or above 80° C [176° F] for extended periods of
time. Doing so may cause permanent damage. (Note that the inside
of a car parked in the hot sun can reach very high temperatures.)
Use of the Lanyard and Cover
The cover can be captured on the lanyard to avoid loss. First, remove
the cord poplock. Then feed the lanyard end through the large opening
in the over and out the slot. Replace the poplock on the lanyard.
Replacing the Battery
When your display becomes dim or disappears,
replace the battery. Use a large coin to open the
battery compartment. Insert a new CR2032 coin
cell (available where watch batteries are sold), positive
(+) pole up. When replacing the battery door, be sure to
keep the black rubber o-ring seated in the groove on
the case back.
mph
mph
MAX
mph
AVG
Current
Wind Speed
Maximum 3-
Second Gust
Since Power On
Average Wind
Speed Since
Power On
MAX
AVG
or
Thank you for purchasing a Kestrel Pocket Weather Meter! Please register your
Kestrel within 30 days of receipt and receive an additional year of warranty
coverage. This information will be kept confidential. Any information collected
about our customers will not be sold or distributed, and will be used for the
business of Nielsen-Kellerman only. We are conducting this survey in order to improve the quality of our
product. Thank you for your cooperation and we appreciate your time.
The team at Nielsen-Kellerman stands proudly behind our products. If you have any questions or comments please feel
free to call us at 1.800.784.4221 or visit our website at www.nkhome.com.
Sincerely,
Nielsen-Kellerman
Sales Department
Kestrel
Pocket Weather Meters
Kestrel
®
1000
Pocket Weather
™
Meter
4) Select the units of measure. Press while holding to scroll
through the units of measure.
+
CR2032
3V
!
C
R2032
Battery
A
s
s
e
m
b
l
e
d
i
n
U
S
A
To Next Page
Need help?
General
