To Next PageTo Next Page
Need help?Do you have a question about the NIFTYLIFT SD50 and is the answer not in the manual?
Overview of components controlling machine operation, including board, alarms, and valves.
Encapsulated control board with PCB for machine operation, including thermal trip switch.
Valve controlling hydraulic supply to drive motors for speed and gradeability selection.
Solid-state sensor monitoring machine inclination, bypassed during driving with lowered booms.
Solenoid-operated valve controlling parking brake, essential for machine movement.
Comply with safety precautions, position on firm ground avoiding hazards.
Levelling machine up to 12 degrees, deploying outriggers for stable support.
Push red emergency stop to shut down. Use manual pump to manoeuvre safely.
Do not exceed capacity, check for obstructions, use power button.
Descend immediately if alarm sounds; do not work near overhead cables.
Do not operate elevated unless on a firm, level surface free from hazards.
Recharge in well-ventilated area; avoid flame/sparks due to explosive hydrogen gas.
Do not leave on charge >24 hours; disconnect when fully charged.
Check lubrication, threads, oil level, batteries, electrics, safety devices.
General