111
Technical Notes
Troubleshooting
If the camera fails to function as expected, check the list of common prob-
lems below before consulting your retailer or Nikon representative. Refer to
the page numbers in the right-most column for more information.
Problem Cause/Solution c
Camera turns off without warn-
ing
• Batteries are low.
• Batteries are cold.
18
106
Monitor is blank • Camera is off.
• Batteries are exhausted.
• Standby mode for saving power. Press
the shutter-release button halfway.
• Flash lamp blinks: wait until flash has
charged.
• USB cable is connected.
• A/V cable is connected.
12
18
13, 23
27
60
59
No indicators displayed in moni-
tor
[Hide info] is selected for [Photo info].
Select [Show info].
94
Monitor is hard to read • Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Monitor brightness at 50% to save
power.
94
106
13
Camera clock is not correct Pictures recorded before clock has been
set will have time stamp of “00.00.0000
00:00”; movies will be dated
“01.09.2006 00:00.” Set the correct
date and time from [Date] in the setup
menu.
14, 91
Camera settings reset Clock battery exhausted. Charge clock
battery.
92
No picture taken when shutter-
release button is pressed
• Camera is in playback mode: press
i.
• Menus are displayed: press m.
• Batteries are exhausted.
• Flash lamp blinks: flash is charging.
24
9
18
27
To Next Page
Loading...
