Nikon COOLPIX P330 - Using the Flash (Flash Modes)

52
Features That Can Be Set Using the Multi Selector
Shooting Features
Using the Flash (Flash Modes)
You can shoot pictures with a flash by raising the flash. You can set a flash mode that
suits the shooting conditions.
1 Lower the K (flash pop-up) control to raise
the flash.
• When the flash is lowered, flash operation is disabled
and S is displayed.
2 Press H (m flash mode) on the multi selector.
3 Use the multi selector to select the desired
mode and press the k button.
• See “Available Flash Modes” (A53) for more
information.
• If the k button is not pressed within a few seconds,
the selection will be canceled.
• When U (auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(A103).
4 Frame the subject and take a picture.
• The flash lamp indicates the status of the flash when
the shutter-release button is pressed halfway.
- On: The flash will fire when you press the
shutter-release button all the way.
- Flashing: The flash is charging. The camera cannot
take pictures.
- Off: The flash will not fire when a picture is
taken.
• If the battery is low, the monitor will be turned off while
the flash is charging.
Auto