33
Using the Flash
Basic Photography and Playback: A (Auto) Mode
Setting the Flash Mode
1
Press the K (flash pop-up) button.
• Built-in flash is raised.
• When the built-in flash is lowered, the flash mode is fixed to W (Off ).
2
Press m (flash mode) on the rotary multi
selector.
• The flash mode menu is displayed.
3
Use the rotary multi selector to choose the
desired mode and press the k button.
• When the manual flash is chosen, choose the flash
output with J or K before pressing the k button.
• The mode selected for the flash is displayed.
• When U (Auto) is applied, D is only displayed for
a few seconds even if monitor indicators (A14) are
turned on.
• If the k button is not pressed within a few seconds, the
selection is set and the setting menu disappears.
B Lowering the Built-in Flash
When not using the built-in flash, gently push to lower the flash until
it clicks shut.
Auto
1/250
1/250
32
32
F5.6
F5.6
To Next Page
Loading...
