Inserting
the
Battery
Removing
the
Battery
Turn the camera
off
and make sure that the power-on
lamp and the
monitor
have
gone
out
before opening
the battery-chamber/memory card slot cover.
To
eject the battery, open the battery-chamber/
memory card slot cover and slide the battery latch
in
the direction shown
CD.
The battery can then be
removed by hand
0.
• Note that the battery may become
hot
during
use;
observe
due
caution when removing the battery.
Turning On and
Off
the
Camera
To
turn on the camera, press
the
power
switch. The
power-on lamp (green) will light for a
moment
and the
monitor
will turn on.
To turn
off
the
camera, press the
power
switch again.
\Nhen the camera turns off,
both
the power-on lamp
and
monitor
will turn off.
~
--
'9
m
~
ON/OF":'§-
i
"
~
Auto Power
Off
in Shooting Mode (Standby Mode)
If no operations are performed for about a
minute
(default setting), the
monitor
will turn
off
automatically and the camera will enter standby mode. If no operations
are
performed for another
three minutes, the
Clmera
will turn
off
automatically (the auto
off
function).
Pressing the power switch, or the shutter-release button, while the
monitor
is
off
in
standby mode
will reactivate
the
monitor.
The
time
allowed
to
elapse from before the camera enters standby
mode
can be changed from the
Auto
off
option
(~
144)
in
the setup menu
(~
133).
17
To Next Page
Loading...
