D1 - PocketWizard Compatibility Mode
The Nikon D1, D1X or D1H radio module inside your camera is compatible with all 32
PocketWizard channels.
To activate the camera’s radio, you will need to plug in the antenna into the front PC sync port of
the camera. The power on default is for the radio to come up in PocketWizard mode.
Channel selection: firing remote flash packs.
The user can change the channel of operation by first setting up a remote receiver on the channel
they wish to use for triggering the flash.
Steps-
1) Turn receiver on and select channel.
If using a MultiMAX, make sure it is set to receive mode.
2) While camera is on, press and hold the “Flash” button on top of camera.
It’s the button next to the “BKT” button.
3) Spin the front command dial (just below the trigger button) up or down while holding the
“Flash” button to change the channel up and down. When you spin the dial and the remote flash
suddenly pops, you have just hit the channel that the receiver is on. If you go below channel 1 it
will wrap around to channel 32.
If you go above channel 32, it will wrap around back to channel 1.
4) To confirm you’re still on the correct channel, press and release again the “Flash” button.
If the flash fires, than you’re on the correct channel and can start shooting. If the flash does not
fire, you might have gone past the channel. If it does not flash when you tap the “Flash” button,
go back to step 3.
The camera will remember the transmit channel once it is set, even if the batteries are removed.
When you power the camera up the next time it will be on the last channel you have selected.