Nikon D300 - Dg-Pcb; CF Base Plate Unit; Image Sensor Holder Unit

- Ｄ  ･ -
logo�Q0310�forGraphic
070509�Gdesign�ito
VBA20001-R.3720.A
Image sensor holder unit
・
Take out the three screws (#1543) and remove the CF base plate (#1018).
・
Unsolder the DR base plate (#1014) at four places.
・
Take out the three screws (#1639) and remove the
image sensor holder unit (#B10521).
#B10521
#1639×3
#1014
DG-PCB
・
Remove the harnesses (#1075, #1074, and #1073) from each connector.
・
Disconnect the FPC (#1027#1027
､
#1040
､
#1041
､
#1039
､
#1038) from each connector.) from each connector.
・
Take out the screw (#1546) and remove [#B1017].
#B1017
#1546
#1041
#1075
#1073
#1040
#1039
#1074
#1027
#1038
CF base plate unit
#1543×3
Orange
Gray
Red
Black
DR base plate
#1018
#1038
INC