319Technical Notes
❚❚ Supplied Accessories
• LC-52 52 mm Snap-on Front Lens Cap
• Rear Lens Cap
❚❚ Compatible Accessories
• 52 mm screw-on filters
• LF-4 Rear Lens Cap
• CL-0915 Flexible Lens Pouch
• HB-37 Bayonet Hood
Align the lens hood mounting mark (●) with the lens hood
alignment mark ( ) as shown in Figure q and then rotate
the hood (w) until the ● mark is aligned with the lens hood
lock mark (—).
When attaching or removing the hood, hold it near the
symbol on its base and avoid gripping it too tightly.
Vignetting may occur if the hood is not correctly attached.
The hood can be reversed and mounted on the lens when not
in use. When the hood is reversed, it can be attached and
removed by rotating it while holding it near the lock mark
(—).
To Next Page
Loading...
