332 Technical Notes
Software Camera Control Pro 2: Control the camera remotely from a
computer to record movies and photographs and save
photographs directly to the computer hard disk.
Note: Use the latest versions of Nikon software; see the
websites listed on page xix for the latest information on
supported operating systems. At default settings, Nikon
Message Center 2 will periodically check for updates to
Nikon software and firmware while you are logged in to
an account on the computer and the computer is
connected to the Internet.
A message is automatically
displayed when an update is found.
Body cap Body Cap BF-1B/Body Cap BF-1A: The body cap keeps the
mirror, viewfinder screen, and image sensor free of dust
when a lens is not in place.
Remote
controls/
wireless
remote
controller
• Wireless Remote Control ML-L3 (0 107): The ML-L3 uses a 3 V
CR2025 battery.
Pressing the battery-chamber latch to the right (q),
insert a fingernail into the gap and open the battery
chamber (w).
Ensure that the battery is inserted in the
correct orientation (r).
• Wireless Remote Controller WR-R10/WR-T10: When a WR-R10
wireless remote controller is attached, the camera can
be controlled wirelessly using a WR-T10 wireless remote
controller (0 109, 282).
• Wireless Remote Controller WR-1 (0 109, 282): The WR-1 can
function as either a transmitter or a receiver and is used
in combination either with another WR-1 or a WR-R10 or
WR-T10 wireless remote controller. For example, a WR-1
can be connected to the accessory terminal for use as a
receiver, allowing the shutter to be released remotely by
another WR-1 acting as a transmitter.
To Next Page
Loading...
