Install Camera Batteries
The Nikon MB-D80 Multi-Power Battery Pack is capable of holding two rechargeable
batteries or six AA batteries. The camera will work properly with only one rechargeable
battery installed. Two batteries give extended operation time. The six AA batteries are
only used if the rechargeable batteries are discharged and there is no electrical power
available to operate the charger, or if time is limited to allow for recharge.
The camera battery door is located on the back of the camera at the bottom. Flip out the
latch and rotate it counter clockwise to open the door. Gentally press the white tab to the
outside of the pack and then insert the battery as shown. To remove a battery, press the
associated white tab to the outside of the pack and the battery will pop out.
If the AA battery accessory is used, install the six batteries while observing proper
polarity. The accessory will move the white tabs as required.
Remove Lens Cap
Turn on the camera
Check Batteries
Note: the battery symbol above shows the status of the battery in use. When two batteries
are installed it is better to follow the procedure below to check battery status.
Press the “Info” button to turn on the Monitor.
The following will show on the Monitor. Both batteries are shown;
the active battery (chosen by the camera) and the standby battery.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
