• Each time you push the SELECT button the blinking section moves in the
order of year, month and day. ' indicates the year section (last two digits)
and m indicates the month section, (< is not imprinted on the picture.)
3 Push ADJUST button to set the year to "00".
• Each time you push the ADJUST button the year section changes as
follows (between 1998 to 2049):
• To change the numerical indication rapidly, hold the ADJUST button down
for more than 1 sec.
4 Set the month and day following steps 2 and 3. When
the setting is complete, push the SELECT button so
the newly adjusted date display appears without
blinking.
• Push the SELECT button until the date display stops blinking. When the
data imprint indicator — appears in the data imprint LCD panel,
date setting is complete.
Adjusting Date and Time and Imprinting Data-continued
5 Push MODE button to select Day/Hour/Minute
display.
6 Push SELECT button so hour section starts blinking.
• Each time you push the SELECT button, the blinking section moves in the
order of hour, minute and : (colon).
7 Push ADJUST button to set the hour to "15".
To Next Page
Loading...
