Nikon SMZ18 - Magnification Change and Power Down; Magnification Adjustment Using Zoom Buttons

Chapter 2 Microscopy Procedures
16
10
Change the magnification by zooming in and out.
Press the zoom buttons on the remote controller to
change the magnification of the zooming body.
• Upper zoom button: Magnification increase
• Lower zoom button: Magnification decrease
The magnification changes in the range from 0.63x to
15.75x.
Pressing and holding the buttons causes the magnification
to change continuously.
1 2 3 4
DISPLAY
DISPLAY
BRIGHTNESS
BRIGHTNESS
ESCAPE
ESCAPE
ALZ
ALZ
−+
LIMIT
LIMIT
ZOOM
ZOOM
STEP
STEP
Z-RESET
Z-RESET
Z-SPEED
Z-SPEED
ZOOM STEP
ZOOM STEP
Coarse
Coarse
FL Cube
FL Cube
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Fine
Fine
Ex Fine
Ex Fine
1x
1x
0.5x
0.5x
0.1x
0.1x
+
−
Zooming in/out
Magnification step size
Each time the zoom step switching button is pressed,
the step size changes in the following order: 1x, 0.5x
then 0.1x. When a step size is selected, the
corresponding step LED indicator lights.
(See Chapter 8, “1.2 SMZ25 Zooming Body.”)
11
Turn off the power after completing microscopy.
Turn off the P2-CTLA Control Box by pressing the power
switch to the “O” position.
Check that the power LED on the control box turns off.
Power off
Zoom step
switching
button
Upper zoom
button
(magnification
increase)
Lower zoom
button
(magnification
decrease)
Power LED: Off
Power switch: “O”
position
Zoom step
indicator