Input the value.
[How to adjust]
・ Turn on the camera.
・ Connect the USB cable to PC.
・ Double-click on "DscCa1Di.exe".
・ Select "Lens Data” on "Test" of "LCD".
・ Input the value of the bar code, which is attached on the rear of the lens, into the text box of “Lens data Dialog”.
Then, click "Set".
・ Click “Exit” and close the dialog box.
11. Lens adjustment
[Preparations]
・ Turn on the collimator (J63090). (Do not connect the USB cable to PC yet.)
・ Turn on the camera.
・ Check the positions so that the chart center in the collimator should be at the center of the screen.
・ Turn off the camera once.
[Conditions]
・ Set the collimator and camera (i.e. the front surface of lens) as near as possible between them (approx.5.5 cm).
・ When the camera is mounted on the cradle, the camera must be right in front of the collimator.
※ Place the cradle in a horizontal position as much as possible. (Fig. 1)
（Fig.1）
Set it horizontally.
Adjustment collimator
Camera
※ ref. Page A1.
To Next Page
Loading...
