176
Technical Notes
Accessories
6 Press and hold (for at least 3 seconds) the power button on the
remote control.
• Pairing starts for the camera and remote control. During the process, the status
lamp on the remote control flashes about every 0.5 seconds.
• When pairing is complete, a connection is
established between the camera and the remote
control. When you enter shooting mode, M is
displayed on the shooting screen.
• If a pairing failure message is displayed, perform
the procedure again from step 5.
Switching the Connection to a Smart Device
• Switch Choose connection (A130) in the network menu from Remote control
to Smart device.
• Paired smart devices are connected to the camera through Bluetooth when the
SnapBridge app is launched. L is displayed on the shooting screen of the camera.
• For connections with smart devices, see the included “SnapBridge Connection
Guide” and SnapBridge online help.
To Next Page
Loading...
