Nikon Z 50 - Energy Saving; Slot Empty Release Lock

325Menu Guide > B The Setup Menu
In photo mode, the shooting display will turn off to save power
approximately 15 seconds before the standby timer expires.
Selecting Enable release allows the shutter to be released when
no memory card is inserted, although no pictures will be
recorded (they will however be displayed in demo mode). If
Release locked is selected, the shutter-release button is only
enabled when a memory card is inserted in the camera.
Energy Saving
G button ➜ B (setup menu)
Option Description
Enable
Enable energy saving. The display refresh rate may
drop.
Disable
Disable energy saving. Note selecting Disable does not
stop the shooting display dimming a few seconds
before the standby expires.
D Note: Energy Saving
• Note that even when Enable is selected, energy saving will not
function:
-If No limit is selected for Custom Setting c3 (Power off delay) >
Standby timer or if the delay selected is less than 30 seconds
-In self-portrait mode
-In U or 6 mode
- During display zoom
- While the camera is connected to another device via HDMI or USB
• Selecting Disable increases the drain on the battery.
Slot Empty Release Lock
G button ➜ B (setup menu)