Points for Safe Attention
Caution: When the machine
is
operated, the following basic safety measures should
be observed to prevent from electric shock, damage and fire.
Children beyond Multifunctional Tool
Do not let the persons, especially for children, reach the tool or electric wire and far
away from the operation site.
Protection from
Electric
Shock
Avoid contacting with grounding parts, such as pipe, electric warmer, electric stove,
refrigerator.
Attention to
Environment
Do not let the tool
be
rained.
Don't
use the tool under the condition
of
humidity.
It
is necessary for operation site to have the adequate light.
Don't
operate the tool
near the place storing the flammable liquid and combustible gas, or the place
storing the explosive materials, for example, near the garage.
PUtting
on
Jumper
Do not carry far clothes or decoration. They can be tangled
by
mobile parts. If
working in the open air, the rubber gloves and skid-proof footwear are
recommendable. Bind your plait shed together or carry a hair net.
Putting
on Glass
and
Face Shield
It is necessary for you to put on the glass and the face shield
in
the dust
environment.
Putting
on
Ear
Shield
If
you work in the heavy noise, it is necessary to put on the ear shield to protect
your
ear.
Keeping Your Body in Stability
Stand on steadily and keep your body
in
balance in any time. Don't climb the
ladder not fastened against the wall. Don't work standing on the chair or similar
matter.
Keeping Site Clean
The disordering working site has the potential
of
hidden danger.
Marking
Location
of
Hidden
Pipe
and
Wire
The electric wire, water pipeline and gas pipe are mounted inside
of
wall. At first,
the location
of
them should be marked.
Using
Correct
Tools
Do not use the improper tools for operation.
Avoid Unintentional
Starting
the Machine
Do not carry tools with the finger at the switch, attached
to
electricity mains. Make
sure that the switch
is
switched
off
to electricity mains with the connection.
Pull the
Power
Supply Plug from the Plug Socket
Pull the power supply plug with non-usage, before the cleaning or maintenance and
before a tool change,
for
example, replacing driller or sharpening grounding rod.
Preventing
Power
Wire
from Damage
When you carry the machine, do not pull the connecting cable and
do
not pull out
the plug from socket. Prevent the power from heating, oiling or contacting with
sharp edges.
Extension
Cable
Line
The extension cable line with the qualified and undamaged indication can
be
used
When you purchase the extension cable line, it
is
necessary to consult with the
related attentions.
You
Are Always Attentive
Observe its work. Advance rationally.
Do
not use the tool if you are unknown
for
the work.
Do not let other persons operate the machine or connect line, hold it
of
the field
of
work away.
Ensure
Workpiece in Stability
Use chip devices or a screw cane in order
to
hold the workpiece
Little
Pressure
You
do
not use
in
the use
of
the multifunctional tools to high pressure; bit
it
and
disks ability broken. Use only clean and sharp accessories parts.
No
Overload for Tool
They work better and more certainly
in
the indicated achievement area.
Maintain its Tools with
Care
Hold its tools sharply and cleanly
in
order to work well and certainly. Follow the
maintenance directions and the references for tool change.
Store its Tool Certainly
Store unused tools in a
dry room. They must be inaccessible for children.
Control its Device on Damages
Control your the device before each utilize on damages. Device or connection
line damages should show, the device may
be
used no longer until these were
removed regular. All parts correctly must be mounted
in order to guarantee the
flawless business
of
the device.
To Next Page
Loading...