Rotary Tool
6
General Precautions (cont’d)
z
Keep cutting tools sharp and clean.
z
Follow all instructions for lubrication and changing accessories.
z
Before using the power tool, check it carefully to ensure that it will
operate properly and perform its intended function.
z
Check that all moving parts are correctly aligned and free from binding.
z
Check for broken or missing parts and have them replaced or repaired
at an authorized service center.
z
If the power tool requires mounting make sure it is securely attached to
a suitable work bench.
z
Check any other condition that may affect the operation of the power
tool.
z
Any damaged guard or any other damaged part of the power tool should
be properly repaired or replaced by an authorized service center unless
otherwise indicated in this instruction manual.
z
Any switch that does not operate correctly must be replaced by an
authorized service center. Do not use the power tool if the ON/OFF
switch does not turn the power tool ON and OFF.
z
Do not attempt to modify the power tool in any way. The use of any
attachment or accessory other than those recommended in this
instruction manual could result in damage to the power tool and injury to
the operator.
z
This electric power tool complies with national and international
standards and safety requirements. Repairs should only be carried out
by qualified persons using original spare parts. Failure to do so may
result in considerable danger to the user.
z
If using the power tool inside your house, protect furnishings and floors
with a suitable dust sheet.
z
Always observe general fire safety precautions when using certain
power tools inside your house or workshop. It is recommended that you
have an appropriate fire extinguisher available at all times while working.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
To Next Page
Loading...
