6
TANK AND FILTER PREPARATION
1. Take the clear 4-mil poly bags with breather holes and set it into the
vacuum tank. There are 1/2" round holes (breather holes) located
about 6" from the top of the bag. Take one of these holes and stretch
it open to approximately 3" in diameter. Using the 3" hole, pass the
tank down tube through the 3" hole and pull the entire bag up and
over the rim, so the top of the bag hangs over the outside of the tank.
Make sure the bag is set-up so that the vacuumed material coming
into the intake and down tube will end up dropping into the plastic
bag. IMPORTANT: All the breather holes MUST be inside the tank.
(See Photo 1)
2. Place the paper collection bag (#520032) into the bottom of the tank.
Pull the cardboard / rubber collar over the down tube, pulling it just
above the rib on the down tube. Then gently pull apart the accordion-
like pleats so that the bag is open. (See Photo 2)
3. Place the cloth filter bag (#862009) with ring in tank. (See Photo 3)
4. Make sure the impaction prefilter (#520316P) is in proper placement
over the HEPA filter, make sure that it covers the entire surface area
of the HEPA filter. (See Photo 4)
5. Place the lid assembly (with the HEPA filter securely bolted in place)
onto the tank and snap the latches into place. (See procedure for
changing the HEPA filter section of this manual) (See Photo 5)
6. Vacuum is ready for use. Plug in vacuum. On/Off switches are
located on the motor dome.
To Next Page
Loading...