9
HOSE AND ATTACHEMENTS / CLEANING TIPS
The #DV15360 vacuum comes complete with 1 1/2" hose, wand, 3"
round dust brush, 9" crevice tool and 5" utility tool. These tools will be
used for contact vacuuming and general purpose clean up. The vacuum
also comes complete with a 3" x 12.5' hose assembly and dryer vent
cleaning "Y" tool.
DRYER VENT CLEANING:
1. To use the "Y" tool for vent cleaning, place the "Y" tool on the ground
on its base with rubber feet.
2. Next, attach the 3" hose to the intake of the vacuum and the opposite
end of the hose to the 3" port of the "Y" tool.
3. Then take the dryer duct and slide it over the 4" end of the "Y" tool.
Turn vacuum on.
4. The third port of the "Y" tool (this port has a plastic cap with slits) is a
“feed through” for agitating tools such as brushes, compressed air,
etc. Run your tool through this port and feed them through the dryer
vent duct. This allows you to agitate and vacuum simultaneously.
CHIMNEY CLEANING:
When using the vacuum to create a negative pressure in a fireplace
during cleaning, connect the 3" hose to the vacuum and place the
opposite end of the hose in the far back corner of the fireplace. Cover the
opening of fireplace and turn on vacuum. (See Photo 5)
To Next Page
Loading...