Need help?Do you have a question about the Niles SI-1260 and is the answer not in the manual?
General| Power Output (8 Ohms) | 60W |
|---|---|
| Number of Channels | 12 |
| Impedance | 8 Ohms |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 10k Ohms |
| Signal-to-Noise Ratio | > 100 dB |
| Bridged Power @ 8 Ohms | 120W |
| Frequency Response (Extended) | 10Hz - 50kHz |
| Signal to Noise Ratio | > 100 dB |
| Total Harmonic Distortion (THD) | 0.05% (1W) |
Details the amplifier's power output capabilities and the technology used to maximize operational efficiency.
Describes the advanced circuitry for operation monitoring, protection, and status indication via LEDs.
Highlights the flexibility of assigning input signals to channels for multi-room audio distribution.
Explains how to bridge channels to create higher-power output for specific applications.
Explains the three selectable modes for automatically turning the amplifier on or off.
Provides guidance on matching speakers to the amplifier's power and impedance capabilities.
Details the types of cables and wires recommended for connecting sources and speakers.
Discusses best practices and recommendations for bridging channels for increased power output.
Explains the use of the Dual BusMatrix Input for simplifying connections in multi-zone systems.
Presents an example of a completed worksheet for documenting system connections and settings.
Explains the three selectable modes for automatically turning the amplifier on or off.
Provides crucial advice on where to install the unit for optimal cooling and safety.
Instructions for connecting audio sources to the amplifier's input jacks.
To Next Page