9
6 Service and Maintenance
Always switch OFF the power and disconnect the power plug for the battery charger from the power
outlet before starting maintenance
6.1 Vacuum Unit, Stick
Body, Charging Base
Wipe off any dirt from the prod-
uct using a dry and soft rag.
In case of stubborn dirt, clean
using a soft damp rag soaked
in a water solution diluted with a
little neutral detergent and then
wipe with a dry rag.
Do not use solvents like thin-
ner, benzene, and spray type
cleaners.
6.2 Dust Container Remove any collected dust in-
side the dust container fi rst and
wash using lukewarm water.
Make sure that the dust con-
tainer is completely dry before
re-assembling.
6.3 Filter Do not wash the fi lters in the
washing machine.
Do not dry them using a hot air
blower such as a dryer or a hair
dryer.
In case of stubborn dirt or loss
in suction power, wash as in-
structed below:
1. Remove the dust fi rst
2. Wash with water
3. Make sure that the fi lters are
completely dry before the
parts are re-assembled.
6.4 Power Brush Carry out the maintenance if
any waste threads or hair gets
tangled in the brush.
Regular Maintenance
Slowly rotate the brush manu-
ally and remove any foreign ob-
jects tangled around the brush.
Maintenance when the power
brush cannot be manually
rotated
1. Unscrew the left hand side
and then lift and dislodge the
brush cover.
2. Lift up the left side of the ro-
tating brush and then remove
the belt from the end of the
rotating brush.
1
2
81942401_UM_HANDY_2-in-1.indb 981942401_UM_HANDY_2-in-1.indb 9 18-01-2010 14:05:1118-01-2010 14:05:11
To Next Page
Loading...
