Nilfisk-Advance SC800 Service Manual

Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 130
3. Next, prepare the upper stack for assembly as shown. Install it and ghten the screw. (Do not over-ghten the
screw or it will strip out the tower).
Drive Wheel
1. Loosen the three nuts securing the wheel to the hub ange.
a. There are 6 nuts on the outer rim of the wheel. Three are for holding the two rim halves together. These
have standard nuts with “star” lock washers. The other three are for securing the wheel to the hub.
These have Nylock style nuts.
2. Raise the wheel o the ground with a jack and remove the 3 mounng nuts.
3. Remove the wheel.
4. Reassemble in reverse order.
Transaxle
1. Empty soluon and recovery tanks.
2. Remove the squeegee tool.
3. Remove the baeries.
4. Remove one drive wheel and remove the transaxle mounng bolts behind it.

Nilfisk-Advance SC800 Specifications

General

Brand	Nilfisk-Advance
Model	SC800
Category	Scrubber
Language	English