EasyManuals Logo

Nilfisk-Advance SDV 8000 User Manual

Nilfisk-Advance SDV 8000
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
English
Technical
Boiler
Wattage:
3000W – (2000+1000)
Type:
Stainless Steel
Capacity:
3.3 Litres
Continuous Fill
Steam Pressure:
8 Bar
Steam at source:
165°C >
Vacuum
Type:
Integral
Motor:
850 Watt
Electrical
Voltage:
230V ~ single phase
Low Voltage Controls:
5V
Cord length:
10m
Capacities
Boiler:
3.3 Litres
Cold Water Tank:
5 Litres (easy fill)
Collection Tank:
12 Litres
Detergent Tank:
2.5 Litres (easy fill)
Weight:
35kg
Trouble
Shooting
No Power
Not connected
or faulty
power cable
Check
connection to
wall socket and
socket switch.
Try in another
wall socket
On / Off
switch not on
Press On / Off
switch which
will illuminate
when on
Fuse blown
Replace fuse
with approved
13A fuse
Unknown
Call for service
No steam
Steam Control
turned down
fully
clockwise
Turn the
control to half
way
Steamer not
ready
Wait for the
“Ready to
steam” light to
illuminate
Clean water
tank is low
(beeping
sound&
"refill" light is
lit)
Pour water into
the clean water
tank until the
beeper stops.
The steam
handle will
work again.
Unknown
Call for service
No steam, Just water
Steamer not
ready
Wait for the
"Ready to steam "
light to illuminate
Boiler at
pressure
and not
heating(tem
perature
less than
110ºC)
Hold the steam
switch on for
approximately
one minute, ever
if just water is
coming out. This
will result in the
heater coming
back on
Unknown
Call for service
Steam Leaking from
front socket
“O” Rings
split
Change and re
grease “O” Rings.
To avoid this
happening ensure
“o” rings are grease
before every use.
“O” rings
worn
Change and re
grease “O” Rings.
To avoid this
happening ensure
“o” rings are grease
before every use.
Vacuum power low
Vacuum
operation
has been
selected
on the
machine
Operate any of the
handle controls,
which will reset the
motor power to full.
Continue
vacuuming
High pitch
motor
noise
Switch the machine
off and empty the
collection tank.
Refill the collection
tank with clean
water to the mark
and recommence
work.
Unknown
Call for service
No detergent
Solution tank
empty
Pour cleaning
solution diluted
in accordance
with the
manufacturer’s
instructions into
the solution
tank.
Unknown
Call for service
Page 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SDV 8000 and is the answer not in the manual?

Nilfisk-Advance SDV 8000 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSDV 8000
CategorySteam Cleaner
LanguageEnglish

Related product manuals