Nilfisk-ALTO SCRUBTEC 343.2 User Manual

ENGLISH USER MANUAL
18 SCRUBTEC 343.2 - 9099636000
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
dened by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the batteries/battery charger
cable disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorised Service
Center. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after
using the
machine
Weekly
Every six
months
Yearly
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and replacement
Solution lter cleaning
Battery charging
WET battery uid level check
Screw and nut tightening check (1)
Brush motor carbon brush check and replacement (2)
Vacuum system motor carbon brush check and replacement (2)
(1) And after the rst 8 working hours.
(2) This maintenance procedure must be performed by Nilsk Alto authorised Service Center.

Nilfisk-ALTO SCRUBTEC 343.2 Specifications

General

Brand	Nilfisk-ALTO
Model	SCRUBTEC 343.2
Category	Floor Machine
Language	English