Squeegee System 121Service Manual – SCRUBTEC R466 ... FOCUS II Micro Rider
Troubleshooting
Trouble Possible Causes Remedy
Dirty water vacuuming is insufcient or
there is no vacuuming
The squeegee or the vacuum hose is clogged or
damaged
Clean or repair/replace
The squeegee leaves lining on the oor
or does not collect water
There is debris under the blade Remove
The squeegee blade edges are torn or worn Replace
The squeegee is not balanced Adjust with the relevant handwheel
The squeegee does not lift/lower See the Electrical System chapter,
function electronic board diagnosis.
The cable is broken Replace
The actuator (M6) is faulty Replace
The actuator fuse (F4) is open Replace
To Next Page
Loading...
Need help?
General
