Nimbus Water Systems WaterMaker Five WM5-50 User Manual

3
42445 Avenida Alvarado, Temecula, CA 92590
(800) 451-9343 · www.nimbuswater.com
Congratulaons on your purchase of the WaterMaker Five reverse osmosis system.
The WaterMaker Five features a four-stage prelter, membrane and posilter
housed in a single cartridge. The h stage, an in-line carbon lter, is placed
between tank and faucet.
When properly maintained, this system will provide you with years of trouble-
free service. The next secons contain important informaon on the proper care
and maintenance of your system, please take a few minutes to read through this
informaon.
The cartridges in this system must be replaced on a regular basis to maintain
eciency and to ensure high water quality. These cartridges work together and
must be replaced every 6-12 months. Any signicant change in performance of
the system should be invesgated promptly to avoid secondary damage or
deterioraon to other parts of the system.
Normally, the reverse osmosis membrane is replaced during an annual lter
change. However, if at any me you noce a reducon in water producon or an
unpleasant taste in the reverse osmosis water, it could be me to replace the
membrane. Nimbus recommends replacing the membrane when TDS reducon
falls below 75%.
In order to ensure the system is funconing properly, a water sample must be sent
in to Nimbus every 6 months for a free diagnosis of your membrane performance.
To send a water sample, use two clean containers and ll one with 1/2 cup of tap
water and the other with 1/2 cup of RO water. Clearly label each sample. Send the
samples to the address listed on the cover of this manual, aenon “Water Sample
Tesng”. Nimbus will test the samples and mail or call you with the results.
CAUTION: Improperly installed systems could result in water damage due to
leaks or ooding. Proper installaon of this system requires familiarity with
standard sink plumbing and proper use of common hand and power tools.
This system has been designed for installaon by licensed professionals, such
as a contractor or plumber.
Introducon to the WaterMaker Five
Stage Descripon
Replacement
Interval
Part
Number
1-4
4-Stage Cartridge
1) 20 micron sediment prelter
2) Granular acvated carbon prelter
3) Reverse osmosis membrane
4) Granular acvated carbon posilter
12 months 104592
5
Granular acvated carbon posilter
(inline between tank and faucet)
6-12 months 104803
The WaterMaker Five uses
the latest in system design
and membrane technology to
reduce the amount of water
down the drain by 50%.
The WaterMaker Five is
smaller and uses signicantly
fewer resources in the
manufacturing process than
the typical 5-stage RO system.
Smaller packaging and a
lighter shipping weight further
reduce impact on the
environment.

Nimbus Water Systems WaterMaker Five WM5-50 Specifications

General

Brand	Nimbus Water Systems
Model	WaterMaker Five WM5-50
Category	Water Filtration Systems
Language	English