10
Receiver outputs
Operating Instructions - SOLO PRO 290 RTF 2.4 GHz No. NE2516
Collective
pitch servo
Pitch-axis
(elevator)
servo
Roll servo
Tail rotor
servo
Front
Collective
pitch servo
Pitch-axis
(elevator) servo
Roll servo
Tail rotor servo
Motor
Battery
Speed
controller
Receiver
Connect the battery char-
ger to the mains PSU, and
plug the PSU into a mains
socket.
The red monitor LED on the
charger lights up, and the
charger emits a brief "beep".
Connect the battery to the
charger.
You will hear a brief "beep"; the green monitor LED flashes during
the charge process.
When the charge process is complete, you will hear a further brief
"beep", and the green monitor LED on the charger glows constantly.
Disconnect the battery from the charger, then disconnect the mains
PSU from the wall socket.
Charging the flight battery
Safety Notes
The battery must not be left unsupervised during the char-
ge process or be placed on an inflammable surface. Protect
from damp. Do not subject it to direct sunshine, and do not
cover the charger.
Do not charge batteries that are hot to the touch. Allow batte-
ries to cool down to ambient temperature. Charge the battery
only using the charger included in the set; do not use any
other charger. The charger should only be used to charge
the battery included in the set. Not suitable for charging the
transmitter battery!
To Next Page
Loading...
